2003 CHEVROLET IMPALA 4DR SEDAN
Security
Battery RED (+) IGNITION SWITCH HARNESS
Ignition PINK (+) IGNITION SWITCH HARNESS
Starter01 YELLOW (+) IGNITION SWITCH HARNESS
AllDoorTrigger RED/WHITE (-) OR BLACK (-) AT PASSENGER PILLAR
TrunkTrigger RED/BLACK (-) IN HARNESS IN DRIVERS KICKPANEL
ParkingLights BLUE (-) AT VEHICLE LIGHT SWITCH
Security
Parking Lights
Interupt with relay
Remote Start
Battery RED (+) IGNITION SWITCH HARNESS
Ignition PINK (+) IGNITION SWITCH HARNESS
Ignition02 DARK GREEN (+) IGNITION SWITCH HARNESS
Accessory01 ORANGE (+) IGNITION SWITCH HARNESS
Starter01 YELLOW (+) IGNITION SWITCH HARNESS
AntiTheftType PASSLOCK II
AntiTheftSystem A RESISTANCE BASED SYSTEM
Tach WHITE (-) AT IGNITION COIL
SpeedSense DARK GREEN (AC) IN HARNESS ON PASSENGER SIDE OF FIREWALL UNDER HOO
ParkingLights BLUE (-) AT VEHICLE LIGHT SWITCH
BrakeLights WHITE (+) AT SWITCH ABOVE BRAKE PEDAL
ReverseLights LIGHT GREEN (+) IN HARNESS AT LIGHT
Remote Start
Accessory 1
WHEN ADDING REMOTE START CONNECT GREEN IGNITION 2 WIRE FROM 6 PIN HARNESS TO ORANGE ACCESORY WIRE. SET GREEN IGNITION 2 WIRE "OFF DURING CRANK"
Doorlocks / Window
PowerUnLock ORANGE/BLACK (-) AT SWITCH IN DRIVERS DOOR
PowerLock ORANGE/BLACK (-) AT SWITCH IN DRIVERS DOOR
DriverDoorMotor01 TAN (+)
DriverDoorMotor02 GRAY (+) AT MODULE BEHIND DRIVERS SIDE OF DASH
Doorlocks / Windows
PowerLock
480 ohm resistor needed
Convenience
HeadLights YELLOW (-) AT VEHICLE LIGHT SWITCH
LowSpeedWipers GRAY (+) AT VEHICLE WIPER SWITCH
TrunkRelease BLACK (-) AT TRUNK RELEASE SWITCH
Mobile Audio / Video
Battery RED (+) IGNITION SWITCH HARNESS
Accessory01 ORANGE (+) IGNITION SWITCH HARNESS
Ground BLACK (-) RADIO HARNESS
Illumination GRAY (+) RADIO HARNESS
Dimmer BROWN (+) RADIO HARNESS
FrontLeftSpeakerPos TAN
FrontLeftSpeakerNeg GRAY
FrontRightSpeakerPos GREEN
FrontRightSpeakerNeg DARK GREEN
RearLeftSpeakerPos BLUE
RearLeftSpeakerNeg YELLOW
RearRightSpeakerPos BLUE
RearRightSpeakerNeg DARK BLUE
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
